Båndfot

Instruction

Switch off the machine. Attach the foot as described in the instruction manual.

Applications:

Sewing on sequin or elastic tapes and normal ribbons

Stitch type: zigzag or decorative stitches (sequins: zigzag)

Stitch width: depends on the stitch (sequins: maximum stitch width or wider than sequins)

Stitch length: depends on the stitch (sequins: maximum stitch length)

Feed dog: raised

Trim the ribbon diagonally and insert it through the presser foot opening and pull it backwards under the foot. Sew on the ribbon, sewing a few securing stitches at the beginning and end of the seam.

Different widths of ribbon can be sewn on, depending on which presser foot guide is used (see illustration):

1. 8-10 mm

2. up to 4 mm

3. 5-6 mm

Note: The screw is only for fastening and should not be adjusted.

Sequin tapes up to 6 mm wide can be sewn on using this presser foot. Pull the sequin tape backwards through the lower opening (1) of the presser foot. Sew on the tape, sewing a few securing stitches at the beginning and end of the seam. It is recommended to use a thread that is the same colour as the sequins or a transparent thread.