Do you want to translate the website to English?
For couching sequin- and satin ribbon. The adjustable guide holds the ribbon in place, preventing it from slipping as it is being sewn on.
A terméket a b77 és b79 gépeken kizárólag az univerzális talpszárral lehet használni. További információért látogassa meg a talpszár termékoldalát.
Switch off the machine. Attach the foot as described in the instruction manual.
Applications:
Sewing on sequin or elastic tapes and normal ribbons
Stitch type: zigzag or decorative stitches (sequins: zigzag)
Stitch width: depends on the stitch (sequins: maximum stitch width or wider than sequins)
Stitch length: depends on the stitch (sequins: maximum stitch length)
Feed dog: raised
Trim the ribbon diagonally and insert it through the presser foot opening and pull it backwards under the foot. Sew on the ribbon, sewing a few securing stitches at the beginning and end of the seam.
Different widths of ribbon can be sewn on, depending on which presser foot guide is used (see illustration):
1. 8-10 mm
2. up to 4 mm
3. 5-6 mm
Note: The screw is only for fastening and should not be adjusted.
Sequin tapes up to 6 mm wide can be sewn on using this presser foot. Pull the sequin tape backwards through the lower opening (1) of the presser foot. Sew on the tape, sewing a few securing stitches at the beginning and end of the seam. It is recommended to use a thread that is the same colour as the sequins or a transparent thread.
