Slēptā dūriena pēdiņa

Instruction

1. Set the machine for a 3-thread overlock narrow (with the right needle), loosen the needle thread tension sligthly.

2. Set stitch length at maximum and differential feed at 1

3. Raise the presser foot and snap on “Blindstitch foot”

4. To place the hem under the foot, fold the hem to the desired width, then fold back, turn and place under the foot (pre-press the hem for easier guiding).

5. Turn the dial (1) to adjust the guide (2) to the left or right until the fold of the fabric is just left of the needle – the needle must stitch into the fold slightly.in line with the needle

6. Lower the presser foot and sew, holding the fabric fold against the guide.

7. After stitching, unfold the fabric and press lightly from the wrong side.

The guide of the foot is also suitable for guiding lace edges to fabric edges.

Change of sewing foot spring

Do you own a sewing foot of the bernette 4 Series?

To ensure that you can use your presser feet with the bernette 64 AIRLOCK model, you need to change the presser foot spring. You will find all information about how to change the spring or remove and attach the presser foot here: