Ruler Foot Set

This foot is ideal to sew along a plexiglass ruler. Note: When using this presser foot make sure the 2mm reduction is active in the "sewing settings - hovering height".

You can also adjust the presser foot height by reducing the presser foot pressure below 0. Lower the feed dog and use without dual feed.

Firmware Update

To use this product, make sure the most recent Firmware is installed on your machine. Visit the support section of your model to download the latest Firmware and step-by-step installation instructions.

Visit the b79

For b77 customers, please contact your dealer to update your machine.

Article number: 502021 03 88

This accessory is compatible with the following machines:

bernette 77
bernette 79
bernette 79 Yaya Han Edition

Scope of Delivery

Ruler Foot JR (1)
Needle Holder (2)

Ruler Foot Set Instructions 1

Installing the Ruler Foot

Update firmware according to «Firmware Update Step by Step».
Switch the machine off and disconnect it from the power supply system.
Remove the presser foot holder.

Ruler Foot Set Instructions 2

Installing the Ruler Foot

Remove the needle and replace the needle holder with the enclosed needle holder.

Ruler Foot Set Instructions 3

Installing the Ruler Foot

Install the ruler foot.

Ruler Foot Set Instructions 4

Adjusting Settings

To raise the foot height further for use with thicker materials, set the presser foot pressure to below zero.

Ruler Foot Instructions 5

Adjusting Settings

Limit the hovering height of the presser foot to maximum 2 mm in the sewing settings for the «Needle Up/Down» button.

Ruler Foot Set Instructions 6

Product Comparison


Features